Industry Express
LED display troubleshooting method
Release time:
2021-08-27
During the use of LED display equipment, it is inevitable that sometimes it will encounter malfunctions. Today, we will introduce how to distinguish and judge the fault diagnosis method of LED display
During the use of LED display equipment, it is inevitable that sometimes it will encounter malfunctions. Today, we will introduce how to distinguish and judge the fault diagnosis method of LED display.
Step 1: Check whether the graphics card setting part is set up properly. The setting method according to the needs is in the electronic file of the CD, please refer to it.
Step 2: Check the basic connection of the system, such as the DVI cable, whether the network cable socket is correct, the connection between the main control card and the computer PCI socket, the serial cable connection, etc., the connection method has been illustrated, please refer to it carefully
Step 3: Check whether the computer and LED power system meet the usage requirements. When the power supply of the LED screen is insufficient, when the display is close to white (high power consumption), it will cause the screen to flicker. Prepare a suitable power supply according to the power demand of the cabinet.
Step 4: Check whether the green light of the sending card flickers regularly. If flickering, go to step 6. If it doesn’t flicker, restart it. Check whether the green light flickers regularly before entering win98/2k/xp. If it flickers, go to the second step. Please check whether the DVI cable is connected properly. If the problem is not resolved because one of the sending card, graphics card and DV cable I is faulty, please replace it separately and repeat step 3.
Step 5: Please follow the software instructions to set or reinstall and then set again, until the green light of the sending card flashes, otherwise repeat step 3.
Step 6: Check whether the green light (data light) of the receiving card flashes synchronously with the green light of the sending card. If it flashes, go to step 8 and check whether the red light (power) is on. Protection) is on, if it is not on, check whether the power supply is connected reversely or if there is no output from the power supply. If it is on, check whether the power supply voltage is 5V. If it is turned off, remove the adapter card and cable and try again. , Replace the receiving card, repeat step 6.
Step 7: Check whether the network cable is well connected or too long (you must use a standard super-category 5 network cable, and the longest distance of the network cable without repeater is less than 100 meters), and check whether the network cable is made according to the standard (please refer to the system installation and setting ), if the problem is not resolved, the receiving card is faulty, replace the receiving card and repeat step 6.
Step 8: Check whether the power light of the large screen is on. If it is not on, go to step 7 to check whether the interface definition line of the adapter card matches the unit board. Note: After most of the screens are connected, there may be no screen or blurry screen in some cabinets. Because the RJ45 interface of the network cable is not connected firmly, or the power of the receiving card is not connected, the signal does not pass through, so please re-plug The network cable (or exchange), or plug in the power supply of the receiving card (pay attention to the direction) can solve the problem.
INFORMATION
Add.: Nangang 3rd Industrial Park, Tangtou Boulevard, Shiyan, Baoan District, Shenzhen, Guangdong, China
Tel/Fax: +86-769 8622 2450
E-mail: info@jptechled.com
NAVIGATION
NEWSLETTER
Subscribe free newsletter to get latest products and discount information.
© COPYRIGHT 2023 Shenzhen JP Technologies Co., Ltd. All right reserved | SEO